- Employers must keep work equipment 'maintained in an efficient state, in efficient working order and in good repair', and keep any maintenance log up to date (PUWER regulation 5).
- Gas tumble dryers: employers must keep gas appliances and flues at their workplace in a safe condition (Gas Safety Regulations, regulation 35), and HSE says work on gas fittings in workplaces such as shops, restaurants, schools and hospitals must be done by a Gas Safe registered engineer.
- Before calling: isolate the machine if it's unsafe, note any error code, the make, model and serial number, and what happened. Don't force a locked door: it may be hot or full of water.
- A service contract should set out planned visits, response times, what's included (parts, labour, call-outs), out-of-hours cover and how quickly a machine will be fixed or replaced.
- Care homes in England: HTM 01-04 asks for a logbook of service and repair visits, and at best-practice level an annual validation of the washer's disinfection stage.
- Repair or replace? Weigh the age of the machine, how often it fails, parts availability, and running costs against a new machine or an all-in monthly plan.
What are the most common commercial washing machine faults?
Not draining, not spinning or stopping out of balance, a door that won't open, not heating, leaks, and error codes on the display. Some have simple causes your staff can check safely; many need an engineer.
| Symptom | Often caused by | Safe first check |
|---|---|---|
| Won't drain | Blocked drain valve, pump or drain; trapped item | Check the drain or trough outside the machine isn't blocked or backing up |
| Won't spin or stops 'out of balance' | Uneven or small load, worn suspension or bearings, drive fault | Re-run with a balanced load: don't spin a single heavy item |
| Door won't open | Safety lock while water or heat is present; lock fault | Wait for the cycle to finish and cool. Don't force it |
| Not heating | Heating element, thermostat or sensor fault; supply problem | Check the programme selected; report the temperature you expected |
| Leaking | Door seal, hoses, drain or overdosing (foam) | Isolate if water is near electrics; note where the water comes from |
| Error code | The controller has detected a fault | Write down the code and what the machine was doing |
What should you tell a laundry engineer?
The make, model and serial number (on the rating plate), any error code, what the machine was doing when it failed, how long it's been happening, and whether it's gas or electric. Photos of the rating plate and display help the engineer bring the right parts.
- Rating plateMake, model, serial number and electrical or gas details: usually on the back or inside the door frame.
- The symptomWhat it did, at which stage of the cycle, and whether it's every time or now and then.
- Error codesExactly as shown on the display.
- Recent changesNew chemicals, a new programme, a move, a power cut or a different type of load.
- AccessWhere the machine is, parking and access times, and who the engineer should ask for.
- UrgencyWhether you have another machine to fall back on, and the impact if it's not fixed today.
What does the law say about maintaining laundry equipment?
Employers must keep work equipment maintained and in good repair, and keep any maintenance log up to date. Gas appliances, pipework and flues at a workplace must be kept in a safe condition, and gas work must be done by someone competent.
- Work equipment"Every employer shall ensure that work equipment is maintained in an efficient state, in efficient working order and in good repair" (PUWER 1998, regulation 5(1)).
- Maintenance logs"Where any machinery has a maintenance log, the log is kept up to date" (regulation 5(2)).
- Gas appliancesGas appliances, installation pipework and flues at a place of work must be "maintained in a safe condition so as to prevent risk of injury to any person" (Gas Safety Regulations 1998, regulation 35).
- Who does gas workNo one may work on a gas fitting unless competent (regulation 3); HSE says that in workplaces such as shops, restaurants, schools and hospitals this means a Gas Safe registered engineer qualified to do the work, and in places such as factories and agricultural premises a competent person (HSE).
- Care providersCQC says equipment used to deliver care must be clean, suitable, "properly maintained", stored securely and used properly, and providers stay responsible when they contract it out (Regulation 15).
- Care-home laundriesHTM 01-04 asks for a logbook of service and repair visits, kept for inspection, and at best-practice level annual validation of the disinfection stage (Social care volume, 3.2 and 3.4).
What should a commercial laundry service contract include?
Planned maintenance visits, a stated response time for breakdowns, what's included (parts, labour, call-outs), what's excluded (misuse, wear items, consumables), out-of-hours cover, records of each visit, and the price and term in writing.
Should you repair or replace a commercial washing machine?
Repair if the machine is otherwise sound, parts are available and breakdowns are rare. Replace, or move to a lease or monthly plan, if it keeps failing, parts are hard to get, it can't run the programmes you need, or its running costs are high.
Lean towards repair
- One-off fault on a reliable machine
- Parts readily available
- It still runs the programmes you need
- Repair cost small compared with replacement
Lean towards replacing
- Repeated breakdowns
- Parts obsolete or slow to arrive
- Can't reach the temperatures or programmes you need
- High water, energy or drying costs
- Your laundry has outgrown it
If you are replacing, our laundry capacity calculator checks whether the same size is still right.
How can you prevent commercial washing machine breakdowns?
Train staff to load and dose correctly, check pockets for coins, pens and keys, clean filters and door seals as the manufacturer says, report noises and leaks early, and keep to the planned service schedule.
- Correct loadingNot overloaded, not a single heavy item, items like horse rugs in a wash bag.
- Pocket checksCoins, keys and pens damage drums, pumps and valves.
- Correct dosingToo much chemical causes foam, leaks and residue; automatic dosing helps.
- Daily cleaningDoor seals, detergent drawers and lint or hair filters, as the manufacturer instructs.
- Report earlyNoises, vibration, slow draining and longer cycles are early warnings.
- Keep recordsA simple log of faults and visits shows patterns, and is required in some settings.
Get quotes for repairs or a service contract
Tell us about your laundry once. We pass it to a specialist UK commercial laundry equipment supplier, who will:
- Talk through your laundry: what you wash, how much, the space you have, and your water, drainage, power and any gas.
- Quote in writing to buy, lease or on a monthly plan, with delivery, installation and servicing shown.
- Explain the service cover: response times, what's included, and who to call when a machine stops.
For businesses and organisations. Prefer email? Write to hello@commerciallaundryhub.co.uk with your business type, size and the machines you need.
Related guides
Commercial washing machine repair: frequently asked questions
How quickly can a commercial washing machine be repaired?
It depends on the engineer's availability, your location and whether the parts are in stock. A service contract with a stated response time gives you more certainty than calling someone new when a machine fails.
Is it a legal requirement to service commercial washing machines?
The law requires employers to keep work equipment maintained in an efficient state, in efficient working order and in good repair (PUWER regulation 5). Planned servicing is the usual way to do that, alongside manufacturer instructions.
Who can repair a gas tumble dryer?
Work on the gas parts must be done by someone competent; HSE says that in workplaces such as shops, restaurants, schools and hospitals this means a Gas Safe registered engineer qualified to do the work.
What does a laundry service contract usually cover?
Planned maintenance visits and breakdown call-outs, with parts and labour included or charged depending on the contract. Check response times, exclusions, out-of-hours cover and whether a loan machine is provided.
Why won't my commercial washing machine door open?
Commercial machines lock the door while there's water, heat or movement in the drum. Wait for the cycle to finish and cool down. If it still won't open, call an engineer rather than forcing it.
Why does my commercial washer keep stopping out of balance?
Usually an uneven load, a single heavy item or too small a load. If it keeps happening with balanced loads, worn suspension, bearings or a sensor may need an engineer.
Should I repair or replace an old commercial washing machine?
Compare the repair cost and the likelihood of more breakdowns with the cost of a new machine, a lease or an all-in monthly plan. Parts availability and running costs often decide it.
Do care homes need to keep laundry service records?
HTM 01-04 says documentary evidence, for example a logbook, of any service and repair visits should be kept and available for inspection, along with local policies for operating the machines.
Sources
We checked the facts on this page against these sources on 18 November 2026. Guidance changes: check the current version before you rely on it.
- Provision and Use of Work Equipment Regulations 1998, regulation 5: maintenance (legislation.gov.uk)
- Gas Safety (Installation and Use) Regulations 1998, regulation 35: duties of employers (legislation.gov.uk)
- Gas Safety (Installation and Use) Regulations 1998, regulation 3: qualification and supervision (legislation.gov.uk)
- Gas safety for employers (HSE)
- Regulation 15: Premises and equipment (CQC)
- HTM 01-04: Social care volume (NHS England, PDF)